I'm preparing a new calibratiob procedure of pressure gauge using hand pump comparison against a master pressure gauge. I try to find a standard procedure including uncertaincy calculation. Please advice where I can find such information and will be very appreciated if someone can give an example document.

THANK YOU.

we, too, use a pump, though i can only give you an overview.

what we do here, we divide the capacity of the pressure gauge under test into 5 test point, and we start from the lowest point and on to the highest point and we then continue in a decreasing order, to at least have an idea of the instrument's hysterysis. the accuracy, you have to compute on your own i think, as it depends on your UUT.

it would be more accurate though if you use a dead weight.

just my two cents

cheers!

[just click the web http://www.hf86.com ,then choose the language
you will see what you want .
we just want to find a good business partner
and if you want ,just send me an email
or add me in to you MSN
hsj8848@hotmail.com
hsj1818@sohu.com

cutelancy,
Don't want to look dumb, but where is the language link for English?