IPC/WHMA-A-620, section 19.6 - Crimp Tools - 30 Day Calibration Period Requirement

[quality1]

We verify our crimp tools daily before use with a simple pull test to ensure the crimp tool is good. We make cables for military and commercial applications.

[ssz102]

In Reply to Parent Post by quality1

We verify our crimp tools daily before use with a simple pull test to ensure the crimp tool is good. We make cables for military and commercial applications.

and your company are produce wire-harness too?

the way of checking instrument as same as mine

[Philium]

In Reply to Parent Post by ssz102

and your company are produce wire-harness too?

Yes, we make wire harnesses.

In Reply to Parent Post by quality1

We verify our crimp tools daily before use with a simple pull test to ensure the crimp tool is good. We make cables for military and commercial applications.

Is dialy verifing voluntary (not required by any standard)?
Some of the terminals we crimp come with the connector and there are no spares, so this would be impossible.

[ssz102]

In Reply to Parent Post by Philium

Yes, we make wire harnesses.

hello. nice to see you with here
and hope to discussion related infor about wireharness manufacture with you

i think that these function test are made necessary such as pull test and retention test or mating and unmating force test
so you will be preparing some spare parts to verify compliance for these equipment