Is it OK to put 2 Part Numbers on 1 PSW (Part Submission Warrant)?

[JaxQC]

The method I used to make the determination was the print. If it was charted and both numbers (LH & RH) were shown on the same chart print (usually symmetrical) then one was ok. If the LH & RH were shown on different prints, then (2) warrants. ie… no more than (1) print per warrant.
Just one opinion.

[jshaw]

I believe it is possible to say "see worksheet" under the part number and have a warrant cover a large list of parts. I have seen this done for minor changes across an entire family that includes many PN's

[glennb185]

The rule is 1 customer part number per warrant unless agreed to by you

[sitapaty]

You have to submit seperate ppaps for them.Because the part nos are differant
Besides both will be rejected if one of the pair is defective.
Sitapaty

[PasiJ]

In Reply to Parent Post by vardar3

My supplier submitted 2 part numbers on 1 PSW:

• it's for a 2 out prog Die.
• Parts are left and right handed.

I have a problem with it, but don't know of a specific rule that prohibits this. Please let me know.

Two different PSW documents and measurement documents. If other PPAP dpocuments are identical those could be used once.