Process Capability to reconfirm the Inspection Frequency

*vimalvg* · #1 21st June 2012, 11:43 PM

Hello,

Can any pls let me know how to reconfirm the frequency of inspection by process capability . We are manufacturing cable harness. In our inspection only measurable parameter is length of the branches and there are some attribute parameters.This is actually our customer requirement. Customer is asking to conduct short term study.

Thanks,
Vimal

**Stijloor** · #2 25th June 2012, 07:44 AM

A Quick Bump!

Can someone help Vimal?

Thank you very much!!

**somashekar** · #3 25th June 2012, 09:32 AM

Quote:

In Reply to Parent Post by vimalvg

Hello,

Can any pls let me know how to reconfirm the frequency of inspection by process capability . We are manufacturing cable harness. In our inspection only measurable parameter is length of the branches and there are some attribute parameters.This is actually our customer requirement. Customer is asking to conduct short term study.

Thanks,
Vimal

If you are talking about crimping process., see THIS

*vimalvg* · #4 26th June 2012, 09:57 AM

Dear Somashekhar,

Customer is asking to check the process capability of final harness and asking to reconfirm the inspection frequency. We are having final length as measurable parameter.I am planning to do capbility on final length. Based on Cpk we need to reconfirm the frequency.Pls let me know whether it is correct or not?.

Regards,
Vimal

	The Deming PDCA Cycle	ISO 9001 QMS Implementation	FMEA Information	APQP Information
Auditing Information	8-D Problem Solving	Statistics	Error Proofing (Poka Yoke)	Brainstorming
Identifying Waste	Pull Systems	Lead Time Reduction	Planned Maintenance	Quick Setup
Discovering Change	Process Capability - Cp vs. Cpk	Histogram Animation	Process Loop Animation	Taguchi Loss Function
		Fishbone / Cause and Effects Animation