Hello to all:
This is question/forum as I am looking on feedback on the usage of Gauge R&R.
Is the Gauge R&R only applicable to dimensions (i.e, length, OD, etc.)?
Have you seen the gauge R&R been performed on outputs such as:
Pressure, Flow Rate, etc. What's your experience if any regarding such outputs?
Thanks in advance.
This is question/forum as I am looking on feedback on the usage of Gauge R&R.
Is the Gauge R&R only applicable to dimensions (i.e, length, OD, etc.)?
Have you seen the gauge R&R been performed on outputs such as:
Pressure, Flow Rate, etc. What's your experience if any regarding such outputs?
Thanks in advance.