apestate
Quite Involved in Discussions
Hello forum
This procedure has some logical problems, but aside from the mistakes of writing quickly, I was hoping someone would be interested in generally critiquing 1.) style 2.) technical content
The calibration procedure isn't written for accredited calibration services or ISO 17025--it would simply be used in an ISO 9001:2000 category job shop.
How do you feel about the content? Measurement uncertainty has been left out entirely. Anything involving torque of measurements has been left out, leaving that up to the operator. Gage block wringing and stacking has also been left out. I haven't included anything about optical flats, and I made attribute judgements out of spindle play, perpendicularity, flatness, etc.
Technically, are any of the instructions inappropriate?
Are there any instructions that should be included?
Is the basic outline style ugly, or inefficient; has too much detail been included for steps? Would a flowchart and data tables be any easier to follow?
Feel free to hack away, I'm looking for good general suggestions. I'd also be interested in anyone's take on the technical content.
--Erik
This procedure has some logical problems, but aside from the mistakes of writing quickly, I was hoping someone would be interested in generally critiquing 1.) style 2.) technical content
The calibration procedure isn't written for accredited calibration services or ISO 17025--it would simply be used in an ISO 9001:2000 category job shop.
How do you feel about the content? Measurement uncertainty has been left out entirely. Anything involving torque of measurements has been left out, leaving that up to the operator. Gage block wringing and stacking has also been left out. I haven't included anything about optical flats, and I made attribute judgements out of spindle play, perpendicularity, flatness, etc.
Technically, are any of the instructions inappropriate?
Are there any instructions that should be included?
Is the basic outline style ugly, or inefficient; has too much detail been included for steps? Would a flowchart and data tables be any easier to follow?
Feel free to hack away, I'm looking for good general suggestions. I'd also be interested in anyone's take on the technical content.
--Erik