A
Arby_gh
Hi,
I want to perform a gage R&R (Crossed) on Gears (involute) over 2-pin measurement.
Does it matter to measure exactly same space between two teeth. Basically,do I need to mark two teeth to put the pins between them and ask inspector measure?Or let the inspectors to put pins between any two teeth and measure it.
Please see attached file.
Thanks,
Arby
I want to perform a gage R&R (Crossed) on Gears (involute) over 2-pin measurement.
Does it matter to measure exactly same space between two teeth. Basically,do I need to mark two teeth to put the pins between them and ask inspector measure?Or let the inspectors to put pins between any two teeth and measure it.
Please see attached file.
Thanks,
Arby