We are a Manufacturing Firm newly established at Lipa City Batangas, Philippines.At present I am handling the Incoming Inspection Section and the Supplier group Section. What do I want to ask for an opinion is that, Is all non-conformity and defect found in line process or in Incoming Inspection should have their corresponhding abnormality report or couintermeasure report eventhough the severity of the deect is quite not critical to the product?
I would much appreciate if you have reply on this matter.
I'm not sure what an 'abnormality report' is but I assume it's just a report saying a nonconformance was identified. A countermeasure report is, I am assuming, a corrective action report.
When you identify a nonconformance you are supposed to identify it and record it, but someone or a group has to determine whether that nonconformance 'requires' a corrective action. Typically a corrective action is not required for every identified nonconformance - you could end up doing little but working on corrective action reports.
Issuing Countermeasure Report - Does every nonconformance identified require an NCR?
Linear Mode
