Quote:
In Reply to Parent Post by amrut1706
What is difference between PPAP & CAPA
|
Both are totally different. Refer below.
Refer
Production_part_approval_process
Production part approval process (PPAP) is used in the automotive supply chain to establish confidence in component suppliers and their production processes, by demonstrating that:
"....all customer engineering design record and specification requirements are properly understood by the supplier and that the process has the potential to produce product consistently meeting these requirements during an actual production run at the quoted production rate." Version 4 March 1st 2006
Although individual manufacturers have their own particular requirements, the Automotive Industry Action Group (AIAG) has developed a common PPAP standard as part of the advanced product quality planning (APQP) – and encouraging the use of common terminology and standard forms to document project status.
CAPA -
Corrective action and preventive action (CAPA, also called corrective action / preventive action) are improvements to an organization's processes taken to eliminate causes of non-conformities or other undesirable situations[1]. CAPA is a concept within good manufacturing practice (GMP). It focuses on the systematic investigation of the root causes of non-conformities in an attempt to prevent their recurrence (for corrective action) or to prevent occurrence (for preventive action).
Corrective actions are implemented in response to customer complaints, undesired levels of internal nonconformity, nonconformities identified during an internal audit or adverse or unstable trends in product and process monitoring such as would be identified by SPC. Preventive actions are implemented in response to the identification of potential sources of non-conformity.
How to check Effectiveness of PPAP
Linear Mode
