vinaysp225
Registered
Hi,Dear All
please help me on this below issue
Recently i sent thread plug gauge for calibration .
after receiving the calibration report its go side pitch diameter out of spec.
M1.7*.35-6H
GO Pitch diameter-1.479±0.0045( Actual: 1.4847)
NOGO PITCH diameter-1.5625±0.0045 (Actual : 1.5703)
GO SIDE OVERSIZE BY 1 MICRON
NOGO SIDE OVERSIZE BY 3 MICRONS.
Please suggests your opinion can i use this gauge further or i want to scrap the gauge.
we have around more than 20 gauges in out of tolerances conditions.
Regards
vinay
please help me on this below issue
Recently i sent thread plug gauge for calibration .
after receiving the calibration report its go side pitch diameter out of spec.
M1.7*.35-6H
GO Pitch diameter-1.479±0.0045( Actual: 1.4847)
NOGO PITCH diameter-1.5625±0.0045 (Actual : 1.5703)
GO SIDE OVERSIZE BY 1 MICRON
NOGO SIDE OVERSIZE BY 3 MICRONS.
Please suggests your opinion can i use this gauge further or i want to scrap the gauge.
we have around more than 20 gauges in out of tolerances conditions.
Regards
vinay