SAMPLE COMPANY                                        Page 1 of 1
SOP # 04-5  Revision: 0                Prepared by:             _
Effective Date:                        Approved by:             _


Title:         DRAWINGS AND SCHEMATICS

Policy:   Engineering Services will be responsible for preparing
          all required drawings and schematics to support product
          design, manufacturing, product service and maintenance
          and for use as illustrations in operation manuals.

Purpose:  To list requirements for drawings and schematics.

Scope:    This procedure applies to all finished products and
          products under development.

Procedures:

1.0  Drawing Requirements

1.1  Engineering will evaluate each product and prepare the
     appropriate drawings and/or schematics as applicable.  These
     drawings and schematics can include the following:

     1.   Schematic diagrams of the individual major assemblies
          and/or the complete equipment of system.
     2.   Logic diagrams.
     3.   Interconnection diagrams.
     4.   Cabling/wiring diagrams.
     5.   Line drawings of the individual assemblies, calling out
          all circuit components.  These drawings are to support
          the parts list and all references must correspond to
          those contained in the parts list.
     6.   Isometric drawings.
     7.   Sheet metal flat drawings.


2.0  Drawing Control

2.1  All drawings/schematics will be properly labeled for
     identification purposes and will include the product or
     component name, drawing number, date, preparer and scale
     used.

2.2  Any changes to a drawing or schematic must be completed in
     accordance with Document Change Control procedures (See
     standard operating procedures for Engineering Change
     Notice).