|
This thread is carried over and continued in the Current Elsmar Cove Forums |
|
|
This thread is carried over and continued in the Current Elsmar Cove Forums |
|
 The Old Elsmar Cove Forums
 QS-9000
 AIAG Control Plan Format (Cathy Peque–o)
|
 UBBFriend: Email This Page to Someone! |
next newest topic | next oldest topic |
| Author | Topic: AIAG Control Plan Format (Cathy Peque–o) |
|
Marc Smith Cheech Wizard Posts: 4119 |
posted 29 June 1998 02:35 PM
   
AIAG DCP format - Posted by Cathy Peque–o on Friday, 26 June 1998, at 9:18 a.m. Why are there three columns in the Characteristics section of the AIAG dcp format: Char. No., Product and Process? What information goes in each of the last two columns? IP: Logged |
|
Marc Smith Cheech Wizard Posts: 4119 |
posted 29 June 1998 02:46 PM
Well, to start off, there are a number of formats you can use for control plans. And, in fact, many companies combine documents. I see combination control plan - flow diagram a lot. But, as to your question... The No. column is for an identifier. Control Plan, FMEA, and Flow Diagram link. Think of this as a cross-reference number. The Product column will have an entry if the characteristic is a product characteristic (eg: no burrs or 0.125 inch). The process column would be if it is a process characteristic (eg: mix ratio). If you take a look at the AIAG APQP manual there are several control plan examples. Check it out. Hope this helps! IP: Logged |
All times are Eastern Standard Time (USA) | next newest topic | next oldest topic |
  |
|
Your Input Into These Forums Is Appreciated! Thanks!
UBB 5.45c
Main Site Search 
