|
This thread is carried over and continued in the Current Elsmar Cove Forums |
|
|
This thread is carried over and continued in the Current Elsmar Cove Forums |
|
 The Old Elsmar Cove Forums
 Statistical Techniques and 6 Sigma
 Dimensionnal caracteristics rating
|
 UBBFriend: Email This Page to Someone! |
next newest topic | next oldest topic |
| Author | Topic: Dimensionnal caracteristics rating |
|
philippe DELMAS Lurker (<10 Posts) Posts: 2 |
posted 10 March 1999 04:55 AM
   
I am looking for practical guideline about DCR. questions to be asked before adding levels on drawings, array with levels/on going manufacturing applied methods If anyone is aware about practical papers I get read you later IP: Logged |
|
Don Winton Forum Contributor Posts: 498 |
posted 10 March 1999 12:45 PM
Dimensional Characteristics Ratings·.hummmmm. That is a new term to me. Can you provide more details? Or, perhaps some else here can help. Regards, IP: Logged |
|
Marc Smith Cheech Wizard Posts: 4119 |
posted 23 March 1999 12:33 PM
I'd like to have information on this as well, if anyone knows anything. IP: Logged |
|
philippe DELMAS Lurker (<10 Posts) Posts: 2 |
posted 23 March 1999 01:23 PM
Sorry for the delay, but I were very busy. The DCR is a rating system that help to cost effective design. I guess it deals with the special caracteristic (appendix C), in fact I would like to confirm this. Though all dimension are to be within the specified tolerance, the practice teach us that some needs more attention. The level gives a range of dimensions from the essentiel one to the minor, and further the way of taking into account control or statistical tool. May be statistical technique is not the right topic because it deals with more general view of the design and its specifications ? IP: Logged |
All times are Eastern Standard Time (USA) | next newest topic | next oldest topic |
  |
|
Your Input Into These Forums Is Appreciated! Thanks!
UBB 5.45c
Main Site Search 
