Posts: 16
From:Portugal
Registered: Feb 99

posted 31 January 2000 05:18 PM               

---

Hi all
After a small discussion in the MSA Forum, some doubts occur which are related to this forum and as suggested my Mark I put the two questions here.
First what is the minimum and maximum value for acceptance of the equipment?
Second what should be the process variation of a measuring range of 1 to 150 mm? 74,5 is a good value?
Tanks in advance,

IP: Logged

Posts: 4119
From:West Chester, OH, USA
Registered:

posted 01 February 2000 03:37 AM               

---

Also see http://Elsmar.com/ubb/Forum4/HTML/000142.html and http://Elsmar.com/ubb/Forum4/HTML/000143.html

IP: Logged

Posts: 4119
From:West Chester, OH, USA
Registered:

posted 01 February 2000 03:46 AM               

---

A second question is:

In MSA manual an example of a linearity studie is present. My question is when they calculate the linearity they they use 6.00 for process variation. Where they find that value?

IP: Logged

All times are Eastern Standard Time (USA)