|
This thread is carried over and continued in the Current Elsmar Cove Forums |
|
|
This thread is carried over and continued in the Current Elsmar Cove Forums |
 Topic Closed
|
 The Old Elsmar Cove Forums
 Tooling and Equipment Suppliers
 Theodolite Calibration
|
 UBBFriend: Email This Page to Someone! |
next newest topic | next oldest topic |
| Author | Topic: Theodolite Calibration |
|
mibusha Forum Contributor Posts: 60 |
posted 15 December 1998 08:46 AM
   
I've just sent out our Theodolite for calibration. That's no problem-takes two days and $225 per head. But does anyone know what to do about the ingar bars? We measure up to ten feet long fictures. Can we use our CMM? If so-what do we measure it to? Sending it out takes up to three weeks and we need it. I am unclear as to the necessity of calibrating the bars. Michael IP: Logged |
|
Marc Smith Cheech Wizard Posts: 4119 |
posted 22 December 1998 10:33 PM
I can't help you on this one. How about it folks? Anyone else with experience here? IP: Logged |
|
mibusha Forum Contributor Posts: 60 |
posted 08 January 1999 06:49 PM
Just to let everyone know-I sent the "invar" bars kit to Kansas (Brunson Company). They will check and send documentation for $210. Michael IP: Logged |
|
Marc Smith Cheech Wizard Posts: 4119 |
posted 08 January 1999 10:13 PM
Thanks for the info. Sorry no one here could help you. I hope this may help someone in the future! Again, thanks! IP: Logged |
|
Bryon C Simmons Forum Contributor Posts: 65 |
posted 11 January 1999 07:59 AM
I dont think I can help you on this one either. IP: Logged |
All times are Eastern Standard Time (USA) | next newest topic | next oldest topic |
  |
|
Your Input Into These Forums Is Appreciated! Thanks!
UBB 5.45c
Main Site Search 
