|
This thread is carried over and continued in the Current Elsmar Cove Forums |
|
|
This thread is carried over and continued in the Current Elsmar Cove Forums |
|
 The Old Elsmar Cove Forums
 Tooling and Equipment Suppliers
 Need Help
|
 UBBFriend: Email This Page to Someone! |
next newest topic | next oldest topic |
| Author | Topic: Need Help |
|
blovstad unregistered |
posted 09 March 2001 10:48 AM
 
We produce pressure washers, that use small gas engines. All of our units a tested 100%, witch requires a small amount of fuel is added to the units. After testing, we remove the fuel from the tank using a small suction pump. The problem is many of the units are getting out with fuel still in the tank. IP: Logged |
|
Al Dyer Forum Wizard Posts: 622 |
posted 09 March 2001 03:57 PM
 
Just a thought from a mechanically challenged person: Could you start the engines and leave them running until they run out of gas, then leave the gas cap off to evaporate the fumes? Works for me every fall. ASD... IP: Logged |
|
Marc Smith Cheech Wizard Posts: 4119 |
posted 09 March 2001 05:22 PM
Don't use fuel from the fuel tank. Test while connected to an outside fuel source. Connect tank to carburator after test. IP: Logged |
All times are Eastern Standard Time (USA) | next newest topic | next oldest topic |
  |
|
Your Input Into These Forums Is Appreciated! Thanks!
UBB 5.45c
Main Site Search 
