The Elsmar Cove Wiki More Free Files The Elsmar Cove Forums Discussion Thread Index Post Attachments Listing Failure Modes Services and Solutions to Problems Elsmar cove Forums Main Page Elsmar Cove Home Page
Welcome To The Old Cayman Cove Forums!
This thread is carried over and continued in the Current Elsmar Cove Forums


  The Old Elsmar Cove Forums
  Measurement, Test and Calibration
  Calibration of analysis program

Post New Topic  Post A Reply
profile | register | preferences | faq | search

UBBFriend: Email This Page to Someone! next newest topic | next oldest topic
Author Topic:   Calibration of analysis program
Edison choi
Lurker (<10 Posts)

Posts: 2
From:Pusan,Korea
Registered: Nov 98

posted 04 November 1998 08:37 AM     Click Here to See the Profile for Edison choi   Click Here to Email Edison choi     Edit/Delete Message   Reply w/Quote
When I visit R&D center,I found some software.this was used for verification of Design. This program is used for analysis of Base Foundation strength. Should this be calibrated or not.If so,where can I find the ISO clouse? I think this should be calibrated. But there is no detail description in ISO 9001.Only described for product related.

IP: Logged

Marc Smith
Cheech Wizard

Posts: 4119
From:West Chester, OH, USA
Registered:

posted 04 November 1998 06:39 PM     Click Here to See the Profile for Marc Smith   Click Here to Email Marc Smith     Edit/Delete Message   Reply w/Quote
I would think the software would come 'certified'. Since software is fixed (except the case of revision) I would think there is nothing to calibrate.

IP: Logged

eastick
Lurker (<10 Posts)

Posts: 2
From:sudbury, ON, Canada
Registered: Oct 98

posted 05 November 1998 10:27 AM     Click Here to See the Profile for eastick     Edit/Delete Message   Reply w/Quote
See 4.11.1 first paragraph.

"The supplier shall ... control, calibrate, and maintain inspection, measuring and test equipment (including test software)..."

I had to address this for my Coordinate Measuring Machine to prove that the mathematical algorithms were correct. I just called the manufacturer and this is apparently standard practice.

I also noticed the the QS9000 PDF files available on Elsmar.com had a good section on Design (EOP-04-01, Sec 4 "Design Aids and Methods" which says:
"Computer software used for carrying out calculations and other design activities is qualified and approved". It goes on to say the various funky ways of qualifying and approving -- including getting a certificate from the s/w manufacturer.

Doug

IP: Logged

BRoyal
Forum Contributor

Posts: 22
From:Charlotte, NC
Registered: Nov 98

posted 18 November 1998 07:37 PM     Click Here to See the Profile for BRoyal   Click Here to Email BRoyal     Edit/Delete Message   Reply w/Quote
Whoa! I blew right past that. Thanks. I have an ISO audit coming up mid-Dec.

IP: Logged

All times are Eastern Standard Time (USA)

next newest topic | next oldest topic

Administrative Options: Close Topic | Archive/Move | Delete Topic
Post New Topic  Post A Reply
Hop to:

Contact Us | The Elsmar Cove Home Page

Your Input Into These Forums Is Appreciated! Thanks!


UBB 5.45c

Main Site Search
Y'All Come Back Now, Ya Hear?
Powered by FreeBSD!Made With A Mac!Powered by Apache!