|
This thread is carried over and continued in the Current Elsmar Cove Forums |
|
|
This thread is carried over and continued in the Current Elsmar Cove Forums |
|
 The Old Elsmar Cove Forums
 Measurement, Test and Calibration
 Gage Labels
|
 UBBFriend: Email This Page to Someone! |
next newest topic | next oldest topic |
| Author | Topic: Gage Labels |
|
Dan M. Lurker (<10 Posts) Posts: 1 |
posted 27 April 1999 10:21 PM
   
ISO says that all gages must have a i.d. number. Is the gage number on the calibration label enough or does it have to be engraved on the gage. If so, how do we mark personel tools, of people who don't approve of an engraver used on their tools. IP: Logged |
|
Don Winton Forum Contributor Posts: 498 |
posted 28 April 1999 09:22 AM
quote: No, it does not. I suspect your current system may, but ISO 9000 does not. ISO 9001; 4.11.2(b) states: identify all inspection, measuring, and test equipment that can affect product quality, and calibrate and adjust them at prescribed intervals, or prior to use, against certified equipment having a known valid relationship to internationally or nationally recognized standards. ISO 9001; 4.11.2(d) states: identify inspection, measuring, and test equipment with suitable indicator or approved identification record to show the calibration status. Key words: 'or approved identification record' and 'suitable indicator.' Records are the key. If the gage is traceable to a record by a 'suitable indicator,' you should be OK. The suitable indicator is entirely up to your organization's best interest. Regards, ------------------ [This message has been edited by Don Winton (edited April 28, 1999).] IP: Logged |
|
Marc Smith Cheech Wizard Posts: 4119 |
posted 01 May 1999 11:45 AM
See http://Elsmar.com/ubb/Forum4/HTML/000069.html for more info on gage labeling. IP: Logged |
All times are Eastern Standard Time (USA) | next newest topic | next oldest topic |
  |
|
Your Input Into These Forums Is Appreciated! Thanks!
UBB 5.45c
Main Site Search 
