Posts: 15
From:Essex, England
Registered: Feb 99

posted 15 June 1999 04:33 AM               

---

Greetings from the UK.
Could someone kindly provide me with some guidance on how to compile a documented scope (and compile a review) for our company's internal calibration activities. This was pulled up in our recent TE-QS9000 registration audit.
Thanks, Sean

IP: Logged

Posts: 89
From:
Registered: Jun 99

posted 15 June 1999 03:44 PM               

---

You might want to do a Search here as well (search ALL forums). For example, there is a thread on scope at: http://Elsmar.com/ubb/Forum1/HTML/000088.html

IP: Logged

Posts: 2
From:
Registered: Sep 1999

posted 02 September 1999 08:01 AM            

---

During our recent surveillance audit, we were given a nonconformance "the laboratory scope does not include equipment calibrated in the plant". We do have a lab scope which includes equipment in our test lab facility, which has been accepted. IMTE in the production units (x-ray gaging, micrometers, calipers, etc.) is under calibration and listed in each areas master list. Calibration occurs at the equipment or within the area of use (taken to an office in the area and calibrated). Does a lab scope really apply here?

IP: Logged

Posts: 64
From:West Chester, OH USA
Registered: Jul 1999

posted 02 September 1999 03:24 PM               

---

They are looking at your in-house calibration as function of the lab. Who does the calibration "at the equipment or within the area of use"? Then you say "(taken to an office in the area and calibrated)" - what do they take to an office to calibrate and who does the calibration. It specifically becomes a 'service' if cal lab folks do the calibration. The situation may be different if the operator, for example, does an equipment verification with golden units. The golden units are standards controlled in the calibration database by the cal lab but the person doing the equipment is not part of the lab services folks. From this the set-up person or operator does not have to have an extensive knowledge of calibration principles and such. The way that they now look at cal labs is almost as an outsourced service and they really would like to see Guide 25 like compliance.

IP: Logged

Posts: 4119
From:West Chester, OH, USA
Registered:

posted 19 March 2000 04:23 PM               

---

See http://Elsmar.com/ubb/Forum1/HTML/000185.html for a good thread on Laboratory Scope.

IP: Logged

Posts: 244
From:
Registered: Sep 1999

posted 20 March 2000 08:55 AM               

---

Check this out for a basic starting point. www.aiag.org/quality/labs.html

IP: Logged

All times are Eastern Standard Time (USA)