The Cove Business Standards Discussion Forums
Monitor the Elsmar Forum
Courtesy Quick Links


Links Elsmar Cove visitors will find useful in the quest for knowledge and support:

Jennifer Kirley's
Conway Business Services


Howard's
International Quality Services


Marcelo Antunes'
SQR Consulting, and
Medical Devices Expert Forum


Bob Doering
Bob Doering's Blogs and,
Correct SPC - Precision Machining


Ajit Basrur
Claritas Consulting, LLC



International Standards Bodies - World Wide Standards Bodies

AIAG - Automotive Industry Action Group

ASQ - American Society for Quality

International Organization for Standardization - ISO Standards and Information

NIST's Engineering Statistics Handbook

IRCA - International Register of Certified Auditors

SAE - Society of Automotive Engineers

Quality Digest

IEST - Institute of Environmental Sciences and Technology

Single Post View
 
Old 13th February 2018, 03:40 PM
Golfman25

 
 
Total Posts: 1,470
Re: Producing IATF 16949 compliant calibration certificates

Quote:
In Reply to Parent Post by AndyN View Post

So a couple of things: Firstly terminology - it's accredited to ISO/IEC 17025. Not certified - an important difference.

Secondly, as the manufacturer, YOU aren't responsible for the calibration of the wrench, the buyer organization is. If you don't provide an accredited 17025 certificate, then the buy must go elsewhere and get their calibration done. Simples!
Actually most buyers would not want to do this as it is probably not necessary. After some use, then certainly they are on their own.

Sponsored Links
 

The time now is 02:29 PM. All times are GMT -4.
Your time zone can be changed in your UserCP --> Options.



Misc. Internal Links


NOTE: This forum uses "Cookies"