The Cove Business Standards Discussion Forums
Please read this thread...
Software update
Monitor the Elsmar Forum
Courtesy Quick Links


Links Elsmar Cove visitors will find useful in the quest for knowledge and support:

Jennifer Kirley's
Conway Business Services


Howard's
International Quality Services


Marcelo Antunes'
SQR Consulting, and
Medical Devices Expert Forum


Bob Doering
Bob Doering's Blogs and,
Correct SPC - Precision Machining


Ajit Basrur
Claritas Consulting, LLC



International Standards Bodies - World Wide Standards Bodies

AIAG - Automotive Industry Action Group

ASQ - American Society for Quality

International Organization for Standardization - ISO Standards and Information

NIST's Engineering Statistics Handbook

IRCA - International Register of Certified Auditors

SAE - Society of Automotive Engineers

Quality Digest

IEST - Institute of Environmental Sciences and Technology

Discussion Thread Title: GRR on ID with set of pin gauges
Single Post View
 
Old 16th May 2018, 08:32 AM
sinned's Avatar
sinned

 
 
Total Posts: 54
Re: GRR on ID with set of pin gauges

Hi Miner,
Yes. You are correct that the resolution will be limited by the increment of those pin gauges. You generally can't go further than 0.005 increment and I doubt if the hand feeling of 0.005 is distinguishable or not. So I usually recommend engineer to explain to customer and seek for their endorsement. The chance customer will accept this is not low to my experience especially when the holes are functioned to have shaft to fit into, ie. the pin gauge measurement simulate better the real world situation as in their assembly process. If you use point touch measurement equipment you may not get the least thru hole diameter.

Sponsored Links
 

The time now is 10:34 AM. All times are GMT -4.
Your time zone can be changed in your UserCP --> Options.



Misc. Internal Links


NOTE: This forum uses "Cookies"