The Cove Business Standards Discussion Forums
Please read this thread...
Software update
Monitor the Elsmar Forum
Courtesy Quick Links


Links Elsmar Cove visitors will find useful in the quest for knowledge and support:

Jennifer Kirley's
Conway Business Services


Howard's
International Quality Services


Marcelo Antunes'
SQR Consulting, and
Medical Devices Expert Forum


Bob Doering
Bob Doering's Blogs and,
Correct SPC - Precision Machining


Ajit Basrur
Claritas Consulting, LLC



International Standards Bodies - World Wide Standards Bodies

AIAG - Automotive Industry Action Group

ASQ - American Society for Quality

International Organization for Standardization - ISO Standards and Information

NIST's Engineering Statistics Handbook

IRCA - International Register of Certified Auditors

SAE - Society of Automotive Engineers

Quality Digest

IEST - Institute of Environmental Sciences and Technology

Discussion Thread Title: GRR on ID with set of pin gauges
Single Post View
 
Old 16th May 2018, 10:37 PM
bobdoering's Avatar
bobdoering

 
 
Total Posts: 4,094
Re: GRR on ID with set of pin gauges

Pins are really no different than the resolution of the lines on a dial or any other gage. I have used "tenths sets" as variable data very readily - if the process variation or tolerance (whichever was applicable) was wide enough. Some people think it is not "continuous" data, but, again, it as continuous as the dashes on your dial gage! One of the best ways to measure MMC including fit.

As far as explaining to a customer, never assume they are more expert than you. Be prepared to train them, if need be.
Thanks to bobdoering for your informative Post and/or Attachment!

Sponsored Links
 

The time now is 09:00 PM. All times are GMT -4.
Your time zone can be changed in your UserCP --> Options.



Misc. Internal Links


NOTE: This forum uses "Cookies"