The Cove Business Standards Discussion Forums
Go Back   The Elsmar Cove Business Systems and Standards Discussion Forums > >
Forum Username

Elsmar Cove Forum Visitor Notice(s)

Rate this Blog Entry

SPC Charting frequency calculator for X hi/lo chart

Submit "SPC Charting frequency calculator for X hi/lo chart" to Twitter Submit "SPC Charting frequency calculator for X hi/lo chart" to Reddit
Posted 16th May 2018 at 11:51 AM by bobdoering
Updated 6th July 2018 at 09:19 AM by bobdoering

One of the things that is unclear with Shewart charts is the frequency of charting. However, with the X hi/lo chart for precision machining, the frequency can actually be calculated. Attached is the Excel calculator for determining frequency. The tool wear rate is based on the linear regression of either the Hi or Lo line of the X hi/lo chart. The resolution is the number of points between adjustments based on the stated tool wear rate. Roundness in the typical amount of roundness for that process.
Attached Files: 1. Scan for viruses before opening, 2. Please report any 'bad' files by Reporting this post, 3. Use at your Own Risk.
File Type: xlsx x hi-lo charting freq calc.xlsx (9.1 KB, 1152 views)
Posted in Uncategorized
Views 1962 Comments 0 Email Blog Entry
Total Comments 0



Do you find this blog post helpful and informational?

The time now is 10:10 PM. All times are GMT -4.
Your time zone can be changed in your UserCP --> Options.

Misc. Internal Links

NOTE: This forum uses "Cookies"