The Cove Business Standards Discussion Forums
Go Back   The Elsmar Cove Business Systems and Standards Discussion Forums > >
Forum Username

Elsmar Cove Forum Visitor Notice(s)

Rating: 3 votes, 2.33 average.

Advanced MSA of Continuous Data Part 4: How to Sample Parts

Submit "Advanced MSA of Continuous Data Part 4: How to Sample Parts" to Twitter Submit "Advanced MSA of Continuous Data Part 4: How to Sample Parts" to Reddit
Posted 28th February 2014 at 09:05 AM by Miner

Another fine article from Minitab on Gauging Gage Part 3: How to Sample Parts.

This article addresses a personal pet peeve of mine. I have seen many posts recommending these same bad practices. As with the three previous posts, Minitab has used the power of Monte Carlo simulation to illustrate why these practices are so bad.
Posted in Uncategorized
Views 13089 Comments 1 Email Blog Entry
Total Comments 1

Comments

  1. Old Comment
    bobdoering's Avatar
    Always a chicken and the egg problem. The conversation seems to start after there is hsitory with the part, but that is not likely the case. Usually, you have a new part, new process...and you need a gage. Make a few parts, but any way to estimate the variation you will see over the life of the process? Oh, and when the designer measured parts to verify his design....what gage did he use? Would it "pass gage R&R"? If not, how much "better" of a gage do you need to make a part than the designer used to validate the design? Aspirin, anyone??
    Posted 5th March 2014 at 04:57 PM by bobdoering bobdoering is offline
    Updated 2nd August 2016 at 09:46 AM by bobdoering
 
Total Trackbacks 0

Trackbacks


Do you find this blog post helpful and informational?

The time now is 10:29 PM. All times are GMT -4.
Your time zone can be changed in your UserCP --> Options.



Misc. Internal Links


NOTE: This forum uses "Cookies"