IEC 61010 - Single Fault Condition - Protective Impedance Implementation

G

guru.ganesheela

I plan to test my equipment in single fault conditions as a part of pre-compliance testing. In that, the first condition is to create a protective impedance and run the equipment. I searched on the internet on how to create a protective impedance. But I didn't find any useful information. Can someone help me out?
 
M

MedMartin

Hello,

what exactly do you want to test?
You can look at your circuit and identify single fault conditions and then test them.
Some examples would be short-circuits on connectors, heaters fully activated, processors in reset, ...
It depends on your device.

Best regards,
Martin
 
Top Bottom