D
Damien.M
My company primarily makes engine gaskets and I'm new to the GD&T and interpreting drawings and blueprints. However, I was looking at a blue print of a muffler gasket and noticed there was no indication of whether the measurements were taken in a free state or constrained state.
If it does not specify does it mean that the engineer forgot to include it? Or do I just assume that it was measured in a free state?
And one more thing, if there is a note that reads "gaskets are to be measured in constrained state", does that mean a free state modifier is needed?
Sorry to you all if my question lacks details for an adequate answer is to be possible.
If it does not specify does it mean that the engineer forgot to include it? Or do I just assume that it was measured in a free state?
And one more thing, if there is a note that reads "gaskets are to be measured in constrained state", does that mean a free state modifier is needed?
Sorry to you all if my question lacks details for an adequate answer is to be possible.
Last edited by a moderator: