J
Jeenan
Hi, again....a little problem.....
When I perform an analysis on a Gauge R & R, I always try to enter a tolerance (so I see the % of R & R and know wright away if I'm below the magic 25%)
That is easy, when I got a +/- tolerance
Ex: 100 (any units) +/- 10.....So I enter tolerance= 20 (total tolerance)
BUT.....How do I enter the tolerance when I only got a maximum....
Meaning: the tolerance for a given test is MAX 100 (so anything below 100 is acceptable)...
Is there a special way to 'calculate' or explain that type of tolerance in Minitab.....
Thanks for helping.....
Jeenan
When I perform an analysis on a Gauge R & R, I always try to enter a tolerance (so I see the % of R & R and know wright away if I'm below the magic 25%)
That is easy, when I got a +/- tolerance
Ex: 100 (any units) +/- 10.....So I enter tolerance= 20 (total tolerance)
BUT.....How do I enter the tolerance when I only got a maximum....
Meaning: the tolerance for a given test is MAX 100 (so anything below 100 is acceptable)...
Is there a special way to 'calculate' or explain that type of tolerance in Minitab.....
Thanks for helping.....
Jeenan