D
daveatwork
I have just completed a crossed MSA on a bore measurement.
Tolerance 0.10mm 3 ops, 10 parts, 3 replicates.
The results show 34% contribution (=NOK as this is > 9%) and 17% against tolerance (=acceptable as this is between 11 - 30%).
Does this mean that the result is acceptable? On the face of it I would think NO as the gauge is thrown out on the % contribution but the relativley high tolerance of 0.1mm suggests that the result is potentially OK.
Any guidance would be gratefully appreciated.
Tolerance 0.10mm 3 ops, 10 parts, 3 replicates.
The results show 34% contribution (=NOK as this is > 9%) and 17% against tolerance (=acceptable as this is between 11 - 30%).
Does this mean that the result is acceptable? On the face of it I would think NO as the gauge is thrown out on the % contribution but the relativley high tolerance of 0.1mm suggests that the result is potentially OK.
Any guidance would be gratefully appreciated.