N
netseal
Hello Forum,
I have got to do the insulation diagram for our medical device. Our device will be classified as 2a device.
The device is a water tub. On top of the water-surface is a latex mat, where the patient is placed on his back. Inside the tub are nozzles blowing water against the patients back. Outside of the tub is a pump for the pressure. The Water gets heated by a coil.
Pump an Heater are without separation connected to the mains (250V).
The heater coil is a rod, inside ceramic and with the resistive heating Element. The outer rod is earthed an placed in the Water. How do I explain this insulation in the Diagram.
It would be very friendly if sombody could help me a little.
Florian
I have got to do the insulation diagram for our medical device. Our device will be classified as 2a device.
The device is a water tub. On top of the water-surface is a latex mat, where the patient is placed on his back. Inside the tub are nozzles blowing water against the patients back. Outside of the tub is a pump for the pressure. The Water gets heated by a coil.
Pump an Heater are without separation connected to the mains (250V).
The heater coil is a rod, inside ceramic and with the resistive heating Element. The outer rod is earthed an placed in the Water. How do I explain this insulation in the Diagram.
It would be very friendly if sombody could help me a little.
Florian