S
superdry123
Hello,
I want to find a poka yoke solution for checking if a C-Clip is properly sitting in its groove. The C-Clip is currently being checked by a gauge pin which has a 2.5 mm diameter. Is there any possibility to check this in another way which is 100% safe. The gap opening (inner diameter) from the C-Clip must be less than 2.5 mm, otherwise the C-Clip doesn't sits properly in its original shape. The tolerances are +-0.05 mm
Would be grateful for some ideas. Thanks.
I want to find a poka yoke solution for checking if a C-Clip is properly sitting in its groove. The C-Clip is currently being checked by a gauge pin which has a 2.5 mm diameter. Is there any possibility to check this in another way which is 100% safe. The gap opening (inner diameter) from the C-Clip must be less than 2.5 mm, otherwise the C-Clip doesn't sits properly in its original shape. The tolerances are +-0.05 mm
Would be grateful for some ideas. Thanks.