AS9100 Inspection records - Is there a requirement to have gauge ID and calibration status

[dmg111]

We are an ISO 9001 machine shop working towards AS9100. Is there a requirement to have gauge ID and calibration status on our in-process and final inspection records? We currently record the gauge number on our final inspection records but not cal status.

Thanks for your input.

 

[Cari Spears]

Hi,

No, there is not an AS9100 requirement to record a gauge ID and calibration status on inspection records - in-process or otherwise. However, most of our customers require this. We manufacture aerospace tooling and equipment.

 

[Ron Rompen]

No requirement under ISO 9001 either. However, you may have customer specific requirements which mandate such things - or an SQA who feels its 'a good idea' to have the gauge number on the control plan/inspection record.

 

[Michael_M]

For the most part, there is no difference in section 7.1.5.2 (Measurement Traceability) between ISO and AS. The only thing that AS adds to this requirement is that the organization establishes, implements, and maintains an ability to recall calibrated equipment that requires calibration and that you maintain a register of the equipment and specific statues.

 

[andrewb91]

We do not, as it is part of our procedures that all gages are verified prior to use in addition to the typical periodic calibration.

 

[dmg111]

Thank you all, this is all very helpful!