P
Hello. I have a piece of 3?X3? Stainless Steel angle that has been rejected because it is not ?square?.
This piece of material does not have any markings to indicate what standard it was produced to. I have purchased two Standards (A276-13 and A582-A582M-12). These ASTM standards do not define dimensional requirements, they only define chemical/mechanical test requirements.
Are there any suggestions as to the correct standard to use that defines the form/dimensional requirement for Stainless Steel angle (3?x3?)?
Thank you,
Phil
This piece of material does not have any markings to indicate what standard it was produced to. I have purchased two Standards (A276-13 and A582-A582M-12). These ASTM standards do not define dimensional requirements, they only define chemical/mechanical test requirements.
Are there any suggestions as to the correct standard to use that defines the form/dimensional requirement for Stainless Steel angle (3?x3?)?
Thank you,
Phil