Has anyone recently taken the GD&T ASME Y14.5M Certification Exam

[optomist1]

Hi To All,

Has anyone recently taken the GD&T Certification exam? If so, how was it? Is the exam based upon Y14.5M 1994?

Thank you...

Optomist1

 

[Stijloor]

Happy New Year!

A Quick Bump!

Can someone help?

Thank you very much!!

 

[Jaded]

No all new exams are based on the current release of the ASTM Y14.5 which is currently Y14.5 2009

 

[Buddy51456]

The Technologist Level exam is a maximum
of four hours,consisting of 100 to 150
questions. The exam is structured as a
closed book, multiple choice, written examination,
evaluating the applicant?s knowledge of GD&T
principles and practices in accordance with the
current Y14.5 Standard.
The topics and approximate distribution of
questions is as follows:
(a) 10% of the questions on Scope,
Definitions, and General Dimensioning.
(b) 10% of the questions on General
Tolerancing and Related Principles.;
Knowledge of former practices included
in Appendix D of Y14.5.
(c) 5% of the questions on Symbology.
(d) 15% of the questions on Datum
Referencing.
(e) 30% of the questions on Tolerances of
Location.
(f) 30% of the questions on Tolerances of
Form, Profile, Orientation, and Runout.
A candidate must achieve at least a 75% grade
overall and at least 50% in each of the above
categories.
The cost is $437.00

Good Luck!

 

[optomist1]

Hi Buddy,

A few months late but thank you, just getting the files and books back out for the home run push......did you take the exam? If so, was it tough?

Regards,
Optomist1