ISO 2553 doc

J

Jim Biz

Anyone have a copy or information on the document ISO 2553?? - it has been vaguley referenced in one of our customers welding specifications & I believe it has to do with describing weld drawing symbols BUT.. we currently do not have more or any-other information than that.

Thanks
Jim

[This message has been edited by Jim Biz (edited 19 September 2000).]
 
J

Jim Biz

:) :) Guess maybe we should just write this one off to a customer that dosen't update his own procedures to current ISO references?

If 1118 folks world wide have never heard of it - it must be buried back on some old dusty shelf somewhere :) :) Even the customers rep couldn't give me a good explaination of why it was referenced...

Regards
Jim
 
J

Jim Biz

Thanks David: We'll make good use of the info-link.. In this case there were no symbols used that were uncommon on any other weld drawings we have. That may be what added to the confusion - quite possible it was used as a draftsman's note to himself as much as anything.

Regards
Jim
 
You must log in or register to reply here.
Top Bottom