Minitab - Updating Graph with specific data points

[zamshabeer]

Hi All

I have a control chart which I had already generated out of baseline data and then formatted the graph with all the annotations that I needed.

I added 6 new data points to the data set, but I would like the graph to be updated with only 4 of the new data points.

Is there a way to update the graph with selected data points?

I don't want to re-run the graph creator again cause I will have to reformat the graph with all of the annotations again.

Thanks
Best regards
Zam

 

[Miner]

I'm not sure whether this is feasible. If you were to update the graph with all the data points, you can try right-clicking the graph and selecting "Update graph now". However, even this will compress the data points horizontally, so you might still need to adjust the position of some annotations. The only way you can exclude the two data points will require creating a new graph.

 

[zamshabeer]

I'm not sure whether this is feasible. If you were to update the graph with all the data points, you can try right-clicking the graph and selecting "Update graph now". However, even this will compress the data points horizontally, so you might still need to adjust the position of some annotations. The only way you can exclude the two data points will require creating a new graph.

Thanks Miner