V
vardar3
I have 9 different parts that are going through the same change "spring tab angle 85° max was 75° +/- 5°"
It is simply an increase of the tolerance, and not a tooling change. If I had my lab guy’s measure 6 pcs of each with a protractor, would that satisfy the dimensional results requirement of PPAP? I have never delt with a PPAP so miniscule and not sure how to handle it.
It is simply an increase of the tolerance, and not a tooling change. If I had my lab guy’s measure 6 pcs of each with a protractor, would that satisfy the dimensional results requirement of PPAP? I have never delt with a PPAP so miniscule and not sure how to handle it.