G
Hello to all.
Recently I got the opportunity to access procedures for Portocal II. We had this software since 2000 (I think), but didn't make much use of it (because we were advised not to, since the company-Wavetek-had been acquired by Fluke and would no longer support it).
However, since quite a few of the procedures I got hold of-through Fluke's site-cannot be found for MET/CAL, I decided to start using Portocal again. Unfortunately, I have ran into problems: many of the procedures simply cannot be imported, and I am getting the message "Cal engine not found". Some of them can be imported and run smoothly.
Does anyone still use this software? I would appreciate any hint-everything I tried following the manual failed
Recently I got the opportunity to access procedures for Portocal II. We had this software since 2000 (I think), but didn't make much use of it (because we were advised not to, since the company-Wavetek-had been acquired by Fluke and would no longer support it).
However, since quite a few of the procedures I got hold of-through Fluke's site-cannot be found for MET/CAL, I decided to start using Portocal again. Unfortunately, I have ran into problems: many of the procedures simply cannot be imported, and I am getting the message "Cal engine not found". Some of them can be imported and run smoothly.
Does anyone still use this software? I would appreciate any hint-everything I tried following the manual failed
