SC in a circle next to feature box - Is this "Statistical Control"

L

lost again

Have SC in a circle next to feature box. Is this "Statistical Control" ? Most of the drawings we get call SPC or SC as a different line.
 
D

db

Re: SC what is it?

There may be better responses, but it could mean that specific callout is a special characteristic.

Also, Welcome to the Cove!
 
Last edited by a moderator:
L

lost again

Re: SC what is it?

I did not say that it is marked on a few round holes that are not anything special.
 

Coury Ferguson

Moderator here to help
Trusted Information Resource
Re: SC what is it?

Have SC in a circle next to feature box. Is this "Statistical Control" ? Most of the drawings we get call SPC or SC as a different line.

South Carolina.

Really, can you post the actual drawing so we can see the call-out?
 
L

lost again

Re: SC what is it?

This fourm will not let me post images until I have been a menber for a bit.
 

Attachments

  • SC.jpg
    SC.jpg
    6.8 KB · Views: 144

bobdoering

Stop X-bar/R Madness!!
Trusted Information Resource
Re: SC what is it?

Looks like Special Characteristic to me. When in doubt, ask the customer.

I agree. While you are asking, you can inquire what Special Characteristic (if it is one) means to that customer, because that can change by customer, too.
 
L

lost again

Re: SC what is it?

It worked, just click on attached thumbnail in above post. Shows SC at end of box. Can't send entire drawing, still in design and build
 

Kales Veggie

People: The Vital Few
It is Special Characteristic.

If you customer used the appropriate FMEA methods:

Your customer assessed the risk of this characteristic as very important because of its severity rating.

In general an SC is carried over from the DFMEA to the PFMEA to the control plan and might require statistical control or other special controls.
 
Top Bottom