Hello,
There is a sentence in MSA which says: "The gage or measurement system should be given a full dimensional layout and functional test, where applicable, at the measurement system supplier before shipment. "
There is a sentence in MSA which says: "The gage or measurement system should be given a full dimensional layout and functional test, where applicable, at the measurement system supplier before shipment. "
This is part of an entire section covering the design and procurement of special purpose measurement systems. If you refer back to Section C on page 25, subsection Complexity, it addresses the scalability of these guidelines (not requirements) based on complexity. Given that, any measurement device that you would purchase "off the shelf" would not require a full dimensional layout, whereas a complex measurement system designed to your specifications may require it.
As to what a dimensional layout is, @Bev D has answered that above.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to the use of cookies.