A
Thankyou 
Let me understand;
Example :
Characteristic : Plastic Injection
Failure mode: Short shoot
Effect: unaceptable appearance / scrap
Potential cause: Poor air pressure
Control Preventive: Set-up sheet, it verify the correct aire pression on the manometer ( 80 - 100 psi )
Control Detection: Start check list
If I define this controls in the FMEA. I must to define the same controls ( preventive & detection ) in the control plan.
Let me understand;

Example :
Characteristic : Plastic Injection
Failure mode: Short shoot
Effect: unaceptable appearance / scrap
Potential cause: Poor air pressure
Control Preventive: Set-up sheet, it verify the correct aire pression on the manometer ( 80 - 100 psi )
Control Detection: Start check list
If I define this controls in the FMEA. I must to define the same controls ( preventive & detection ) in the control plan.