I have been tasked with writing a calibration procedure for Groove micrometers. I would appreciate any input fellow covers can provide as I am lost on this one.
I have been tasked with writing a calibration procedure for Groove micrometers. I would appreciate any input fellow covers can provide as I am lost on this one.
Are you going to calibrate the micrometer or verify the accuracy of micrometer? To have a procedure to verify accuracy is simple, but to calibrate a micrometer which i suppose accurate to 0.001mm, would be hell a lot of headache.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to the use of cookies.