|
This thread is carried over and continued in the Current Elsmar Cove Forums 
|
|
|
This thread is carried over and continued in the Current Elsmar Cove Forums
|
The New Elsmar Cove Forums
|
 The New Elsmar Cove Forums
 QS-9000
 T. & E. Supplement
|
 UBBFriend: Email This Page to Someone! |
next newest topic | next oldest topic |
| Author | Topic: T. & E. Supplement |
|
B. Maynard Forum Contributor Posts: 23 |
posted 23 February 1999 01:05 PM
   
Reliability & Maintainability Clause 4.20 etc. What is the easiest way for analysis. We are Mold-Makers & Plastic Injection Molding Producers.We use X-Bar & R and P-Charts on all jobs along with initial capability studies. IP: Logged |
|
Marc Smith Cheech Wizard Posts: 4119 |
posted 27 February 1999 06:27 AM
I'm not the statistical person - I think Don is - but it sounds like what you're doing will be OK. They may ask you to explain your rationalization. By the way - you may want to post this question in the T&E forum here at the Cove. Bryon is the moderator and may be able to help. [This message has been edited by Marc Smith (edited 02-27-99).] IP: Logged |
|
Don Winton Forum Contributor Posts: 498 |
posted 27 February 1999 10:57 AM
quote: As long as you can show that the particular charts are applicable to the operation, you should be fine. Be ready to explain your intent in meeting the requirements, and show that the particular statistical technique is applicable. Regards, IP: Logged |
All times are Eastern Standard Time (USA) | next newest topic | next oldest topic |
  |
Hop to: |
Your Input Into These Forums Is Appreciated! Thanks!
Main Site Search 
