|
This thread is carried over and continued in the Current Elsmar Cove Forums 
|
|
|
This thread is carried over and continued in the Current Elsmar Cove Forums
|
The New Elsmar Cove Forums
|
 The New Elsmar Cove Forums
 QS-9000
 Mechanical Drawing Aprovals
|
 UBBFriend: Email This Page to Someone! |
next newest topic | next oldest topic |
| Author | Topic: Mechanical Drawing Aprovals |
|
mibusha Forum Contributor Posts: 60 |
posted 06 October 1999 06:25 PM
   
Somewhere I have seen it written that before release mech prints must be signed by the originator, checked by a second person, and then approved (not necessarily by either of the first two people). It is in my procedures but now I can't find where it calls for it in the standards. (ISO 9001, QS 9000, TE). Did I just make it up? Michael IP: Logged |
|
Sam Forum Contributor Posts: 244 |
posted 07 October 1999 09:26 AM
You might check the ANSI drafting standards. I seem to remember something there about sign-off responsibility. It's a long reach, but you can get there from QS-9000. IP: Logged |
All times are Eastern Standard Time (USA) | next newest topic | next oldest topic |
  |
Hop to: |
Your Input Into These Forums Is Appreciated! Thanks!
Main Site Search 
