|
This thread is carried over and continued in the Current Elsmar Cove Forums 
|
|
|
This thread is carried over and continued in the Current Elsmar Cove Forums
|
The New Elsmar Cove Forums
|
 The New Elsmar Cove Forums
 QS-9000
 GAGE R&R AND CALIBRATION
|
 UBBFriend: Email This Page to Someone! |
next newest topic | next oldest topic |
| Author | Topic: GAGE R&R AND CALIBRATION |
|
jet3sons Lurker (<10 Posts) Posts: 1 |
posted 30 January 2001 03:36 PM
  
We recently purchased calibration software that also does gage R&R. Is it permissible to use data from calibrations as part of a gage R&R? Also, are there any "standards" for calibration/gage R&R for mics, calipers, etc.? IP: Logged |
|
Al Dyer Forum Wizard Posts: 622 |
posted 30 January 2001 05:48 PM
For question #1, I don't see how the data can be mixed. Calibrations verify conformance to a known, traceable standard. R&R is measuring gage and assessor variation to a specific part. As for standards to be applied, I can only suggest the AIAG QSR & MSA manuals and a search of the FTP site on the forum. Let's here from some of the inspection/test equipment gurus! ASD... IP: Logged |
|
Wayne Stubbs Lurker (<10 Posts) Posts: 3 |
posted 08 May 2001 11:56 AM
I'm inclined to agree, the two do not mix. Gauge R&R requires different operators. Calibration in most companies centre around one technician. I would not shortcut here, ensure your equipment is calibrated then develop an R&R programme for your equipment along the lines of your calibration programme but seperate. IP: Logged |
All times are Eastern Standard Time (USA) | next newest topic | next oldest topic |
  |
Hop to: |
Your Input Into These Forums Is Appreciated! Thanks!
Main Site Search 
