|
This thread is carried over and continued in the Current Elsmar Cove Forums 
|
|
|
This thread is carried over and continued in the Current Elsmar Cove Forums
|
The New Elsmar Cove Forums
|
 The New Elsmar Cove Forums
 Statistical Techniques and 6 Sigma
 SPC - go/no go setup
|
 UBBFriend: Email This Page to Someone! |
next newest topic | next oldest topic |
| Author | Topic: SPC - go/no go setup |
|
S. Smith unregistered |
posted 03 November 2000 04:21 PM
 
Forgive me for my ignorance...My company is set up to check every part number (1 out of every 25) we run to a check fixture. It is either good or bad. Please tell me how I go about setting up SPC's for such an environment. As a side note. Every part that we produce may have upwards of 15 different measurements per piece. thanks in advance. IP: Logged |
|
Al Dyer Forum Wizard Posts: 622 |
posted 03 November 2000 05:31 PM
 
S. Smith, Consider using a "U" or a "C" attribute chart. The AIAG SPC manual would be a good source for initail details. ASD... ------------------ IP: Logged |
|
S. Smith unregistered |
posted 07 November 2000 09:47 AM
Thank you. IP: Logged |
All times are Eastern Standard Time (USA) | next newest topic | next oldest topic |
  |
Hop to: |
Your Input Into These Forums Is Appreciated! Thanks!
Main Site Search 
