posted 13 January 2000 09:51 AM              

---

Somebody could tell me the answer for this question?
On the APQP manual Section 6.2 (Overview) specify that a control plan describes the actions that are required at each phase of the process including receiving, in-process, out-going, etc.
Does it mean that I must include every single operation involve on manufacturing process or just the one that we identify as critical operation in every phase?

IP: Logged

Posts: 4119
From:West Chester, OH, USA
Registered:

posted 14 January 2000 09:18 AM               

---

Technically, you only have to put critical operations on the control plan as determined by the Process and/or Design FMEA. However, you still have to have a Process Flow Diagram and FMEA (if automotive). In those every step must be addressed.

IP: Logged

All times are Eastern Standard Time (USA)