Posts: 3
From:Bangkok,Thailand
Registered: Oct 2000

posted 20 October 2000 10:59 PM               

---

I'm suffering about applying Design/Development requirement in iso9001:2000 to my inspiration design like gems and jewelry. Most designer do it from their imagination and a little bit of customer requirement. Our design depend on fashion and customer styles. How can i apply it?
I'm look forward to your helping..

Yours faithfully
Krit Pattamaroj
Topaz Group Inc.

[This message has been edited by topaz boy (edited 20 October 2000).]

[This message has been edited by topaz boy (edited 20 October 2000).]

IP: Logged

Posts: 637
From:South Central Massachusetts
Registered:

posted 22 October 2000 08:42 PM               

---

Your design input is your "fashion research findings" as well as the customer requirements (Contract Review?)you mention. Your design plan would be identifying at what stages you would look at the input again and see if you are still on the right course...and of course who needs to be included as well as what measures/output will be needed at each stage. Identify the charastics for the design/piece and how you will measure them. Does the design input meet the output, and does it meet its intended purpose? How do you know? ...Out put can be either the jewelery piece itself or the paperwork it will be made from.....the output needs to be identified as apart of the 'plan".

IP: Logged

All times are Eastern Standard Time (USA)