|
This thread is carried over and continued in the Current Elsmar Cove Forums 
|
|
|
This thread is carried over and continued in the Current Elsmar Cove Forums
|
The New Elsmar Cove Forums
|
 The New Elsmar Cove Forums
 APQP and PPAP
 Are ppap's required on steel?
|
 UBBFriend: Email This Page to Someone! |
next newest topic | next oldest topic |
| Author | Topic: Are ppap's required on steel? |
|
JPeters unregistered |
posted 19 October 2000 09:01 AM
 
Our registrar wrote a minor in an audit b/c my company did not have ppap packages on file from our steel suppliers. In the PPAP 3rd Edition book it does state that for bulk, raw or indirect material, it is the Procurring Division's decision whether ppap is required. Wouldn't this fall into that clause? IP: Logged |
|
Rea Forum Contributor Posts: 12 |
posted 19 October 2000 09:35 AM
Can you guote the section of the PPAP manual you are refering too? IP: Logged |
|
JPeters unregistered |
posted 01 November 2000 12:05 PM
The section I am quoting is Under Appendix F under F.2 Applicability. IP: Logged |
|
Rea Forum Contributor Posts: 12 |
posted 13 November 2000 10:05 AM
This I beleive states that if the OEM approved the steel supplier then there is no requirement for you receive a PPAP from the steel supplier. IP: Logged |
|
Sam Forum Contributor Posts: 244 |
posted 13 November 2000 12:16 PM
Para F.2 infers that when an OEM approves a PPAP for a bulk material then you do not need approval for the material when used in other products. Also see F.4, contact your customer about the need for a PPAP. Your auditor is correct in issuing a minor; you did not have documented evidence that a PPAP was not required. IP: Logged |
All times are Eastern Standard Time (USA) | next newest topic | next oldest topic |
  |
Hop to: |
Your Input Into These Forums Is Appreciated! Thanks!
Main Site Search 
