|
This thread is carried over and continued in the Current Elsmar Cove Forums 
|
|
|
This thread is carried over and continued in the Current Elsmar Cove Forums
|
The New Elsmar Cove Forums
|
 The New Elsmar Cove Forums
 Measurement, Test and Calibration
 How to calibrate V-Blocks
|
 UBBFriend: Email This Page to Someone! |
next newest topic | next oldest topic |
| Author | Topic: How to calibrate V-Blocks |
|
Santo Lurker (<10 Posts) Posts: 2 |
posted 08 September 1999 09:22 AM
   
Recently, I have come across some tool and gage material at work. This is all new to me being that for the past 8 years I have been doing mostly optical alignment calibrations. I have an idea of how to calibrate V-Blocks but am not sure if I have everything I need and the procedure in doing these in-house. We do however, have a temp controlled lab for calibrations. Can someone please help? IP: Logged |
|
Kevin Mader Forum Wizard Posts: 575 |
posted 08 September 1999 04:17 PM
I have a book back in my office that has a procedure on how to calibrate a V-block. I remember having that on an ASQ CMI exam, the only way I would even know I have it. I will be back in the office on Monday, so I will take a look and fax you what I can. I hope you can wait, but if not, perhaps someone out there can help you out sooner. As I recall, you do the calibration using gage pins, dial indicator, and perhaps a cylindrical square on a surface plate. Best I can do off the top of my head. Regards, Kevin IP: Logged |
|
Santo Lurker (<10 Posts) Posts: 2 |
posted 08 September 1999 04:44 PM
Kevin, Yes I can wait, but if anyone else out there has info it would be greatly appreciated. Thanks IP: Logged |
All times are Eastern Standard Time (USA) | next newest topic | next oldest topic |
  |
Hop to: |
Your Input Into These Forums Is Appreciated! Thanks!
Main Site Search 
