|
This thread is carried over and continued in the Current Elsmar Cove Forums 
|
|
|
This thread is carried over and continued in the Current Elsmar Cove Forums
|
The New Elsmar Cove Forums
|
 The New Elsmar Cove Forums
 Measurement, Test and Calibration
 Targets for Linearity
|
 UBBFriend: Email This Page to Someone! |
next newest topic | next oldest topic |
| Author | Topic: Targets for Linearity |
|
Bharder unregistered |
posted 05 September 2000 05:56 PM
 
I am looking for some recommendations for acceptance criteria for QS-9000 linearity studies. The MSA manual does not define acceptance criteria it just says that regression line should have a good linear fit(R squared) and good linearity or low slope. The auditor says I must have values or targets stated for these characteristics. I can't find any guidelines. Any ideas? IP: Logged |
|
Marc Smith Cheech Wizard Posts: 4119 |
posted 10 September 2000 09:23 PM
 
As I understand it, you take the value of the instrument's range deviation and look at it as a % of the spec range. Was this brought up with respect to your uncertainty budget? IP: Logged |
|
e.s.deo Forum Contributor Posts: 13 |
posted 18 September 2000 12:53 PM
Dear Bharder, You hv to consider linearity as a proportion of the total r&r Thanks IP: Logged |
All times are Eastern Standard Time (USA) | next newest topic | next oldest topic |
  |
Hop to: |
Your Input Into These Forums Is Appreciated! Thanks!
Main Site Search 
